Risk of electric shock with exposed live terminals

The exposed live terminals , were found by a Veriserv engineer whilst carrying out a routine electrical fixed wire inspection and test  at a commercial property. Although this fault was found in a plant room where there is no public access, to workers it poses a significant risk of electric shock with exposed live terminals.

The engineer effected an immediate temporary repair to make this safe, by covering the exposed live terminals and open terminal box with insulating tape to prevent anyone touching the terminals.

The fault was then formally reported to the customer on a Veriserv “immediate” report which would be signed by the customer to acknowledge the fault and act as a hard copy reminder to facilitate a remedial repair. The “immediate report” is a useful way of immediately notifying a customer of all faults found during the fixed wire inspection and test by noting the category of faults helping our customer understand how to prioritise the remedial repairs. All category 1 faults such as this would need immediate rectification or temporary repair, otherwise the circuit would need to be isolated to make safe until a repair can be completed. All Veriserv engineers would provide expert advice and recommendation whilst on site. This is important as the full inspection & test report would follow later. If you need advise please call us on 01543 225306 or complete an Contact us form.

The Electricity at work regulations 1989 sit under the Health & Safety at work act 1974 and impose duties on employers and “duty holders” in respect to electrical systems, electrical equipment and conductors.

The purpose of the regulations is to is to prevent death or personal injury to any person from electrical causes in connection with work activities.

Employers and self employed people must comply with the provisions of the Electricity at work regulations 1989. Regulation 4 (2) states that as necessary to prevent danger , all systems shall be maintained so as to prevent , so far as reasonably practicable , such danger.

A duty holder can demonstrate compliance with the regulations, in respect to their electrical installation, by carrying out an electrical fixed wire inspection and test. As Veriserv are an NICEIC accredited company, we are experts in this area and are happy to advise you on the frequency, scope and cost of the test, having first considered the environment and use of the premises concerned.

If you need advise please call us on 01543 225306 or complete a Contact us form.

 

Leave a Reply

Your email address will not be published. Required fields are marked *